Speed Interface Trunk 2960 Switch Change from 1000Mb/s to 100Mb/s …
The fact is that suddenly the value changed from 1000Mb/s to 100Mb/s, when both interfaces were in auto So now with both interfaces forced to be in speed 1000, the Trunk is working well at 1000Mb/s. …
Mismatched duplex setting - Cisco Learning Network
Full-duplex, 100Mb/s, auto negotiation: off, uni-link: n/a Up 9 hours, 31 minutes, 37 seconds Loopback Mode : None 468 link status changes since last clear Last clearing of "show interface" counters 76 …
Understanding duplex and speed terminology - Cisco Learning Network
Hello, I just completed the INCD1 and 2 class and really need some help as to the best way to study and prepare for the test. Any advice will do I have Wendell Odem's book and Cisco packet tracer. When …
Link between two Gigabit Ports operating at 100mb
Hello Guys. I have two Cisco C2960-24TT-L with two gigabit ports connected using CAT6 UTP cable to a Cisco C2960-24TC-S also with two gigabit ports. Gig0/1 connects to Gig01 and Gig0/2 connects to …
Half-duplex as default autonegociation for 10 and 100 Ethernet.
Does it mean a faulty port ? In that case, assuming a malfunctioning port, auto-negotiation is not even expected or may not be predictable. And: nazim wrote: there are no settings for 100MB so if it works …
No gigabit speed between switch and router - Cisco Learning Network
As usual, the show output on the router's gig/01 interface shows 100Mb/s while the interface on the switch (gig0/1) shows 1000Mb/s. It doesn't matter if I set it manually or use autonegotiation, the …
Difference between Bandwidth command and Speed command
The speed command is the rate at which the information is sent from one end of the link to the other end ie; 10Gig, 1Gig, 100Mb, 10Mb. These are hard coded and cannot be specified to the actual …
A question on the result of the failed auto-negotiation on the side ...
"Switches detect duplex settings through autonegotiation only. If both ends have autonegotiation enabled, the duplex is negotiated. However, if either device on the cable disables autonegotiation, …
gigabitethernet0/0 is up while the line protocol is down (disabled)
I am using Cisco packet tracer.I connected two routers using a crossover cable.My interface gigabitethernet0/0 is up while the line protocol is down (disabled) . I used the no shutdown option.I …
Connect SFP multimode 100Mb to a 1000MB SFP on switch
I want to know if I can connect a server with a 100Mb fibre multimode interface to a 1000Mb SFP (GLC-SX-MMD) on a Cisco 3850 (WS-C3850-24S-E). Is any problem with the speed negotiation of each …